Ivory 310
High Build Epoxy Tar

PRODUCT DATA SHEET

Description
Solvent free epoxy tar with excellent chemical resistance.

Uses
A highly chemical resistant epoxy coating used in the lining of storage tanks, sewerage plants, effluent sumps and pumps and as a coating on steelwork, machinery, piping, concrete structures, floors and woodwork, to protect against attack by corrosive chemicals and gases; mixed with aggregate for road paving.

Advantages
• Excellent chemical resistance.
• Easy to apply.
• Good flexibility and impact resistance.
• Solvent free - no volatile fumes.
• High build coating - 250 microns per coat.
• Cures at low temperatures.
• Can be reinforced with fibreglass cloth.
• Can be used as a mortar for paving with the addition of aggregate.

Resistance
Good resistance to fumes, splashes and spillages of most inorganic acids at various concentrations. Resists alkali’s such Sodium Hydroxide and ammonia. Resists Hydrocarbon fuels and oils. Contact the Technical Department for specific resistance information.

Preparation
All surfaces to be clean, dry and sound in accordance with Ivory Surface Preparation specification for the substrate to be coated. Abraded surfaces improve adhesion. Holes in concrete substrates to be filled with an epoxy putty or mortar. Holes in wood or steel to be filled with Ivory 319. Blasted steel surfaces to be primed with Ivory 366. Mechanically prepared surfaces to be primed with Ivory Ivomastic.

Specification
All surfaces to be prepared and coated with two coats of Ivory 310 High Build Epoxy Tar all in accordance with manufacturer’s detailed instructions.

Application
Stir the contents of the two containers well. Using volumes strictly in accordance with the given mixing ratio, mix the contents of the two containers together for 5 minutes using a flat piece of wood or spatula. On areas continuously wet or where fats, oils or grease are present, a non slip surface can be provided by sprinkling an amount of Ivory Non Slip Aggregate to the uncured primer or first coat. Before over coating, sweep off excess aggregate with a stiff nylon broom. Should over 18 hours have elapsed between coats, abrade the surface and wipe with Ivory Epoxy Thinners. If the material is left in the container it will become unusable within half an hour. Do not apply if relative humidity
exceeds 85%.

Health & Safety
Some of the components of this product may be hazardous during mixing and application. Please consult the relevant Health & Safety Data Sheet available from Flowcrete on request and sent with each delivery.

                                                                                                                                                                                        www.flowcrete.com